Vector 3 Temperature Fix and How To Set The Bed Height with Gcode (useful in OctoPrint) | #V3

In this episode, I talk about the vector 3 printer and how to overcome a temperature issue that some people are having with the 3D Printer getting up to temperature. Also, I explain how to Set the bed on the printer with GCODE (this is useful when it comes to using OctoPrint.) – Thanks Andrew!

Thanks a lot for watching please check out the links below, help me grow and support me if possible via spreading the word. You can also support me by donating to me on Patreon, watching the adverts, or using affiliate links when possible. Thanks for reading!

++Social Media Links

++Check out this little tabletop project, called Project1! (I’ll change it later most likely)

++Check out my website below!

++I Sometimes stream on Twitch!

++Check out some cool Merch

++Become a Patreon! Every dollar is appreciated!

++Special Thanks To Our Patreons for Helping to grow the channel!
Jamie Robinson

Add a Comment

Your email address will not be published. Required fields are marked *

Privacy Preference Center

Close your account?

Your account will be closed and all data will be permanently deleted and cannot be recovered. Are you sure?

Are you sure?

By disagreeing you will no longer have access to our site and will be logged out.