Adding feet to the 3D printer, does it help? The answer probably won’t shock you.. | #3DPRINTING

In this video, I add some feet to the 3D printer to see if it helps the rigidity of the printer. Stick around and find out the results! Please let me know in the comments below if you have had similar experiences. Also, don’t forget to subscribe for more cool content.

adding some feet to the 3D printer

When I entered into this I was fully expecting the feet to add some rigidity to the printer, because of how much the printer moved about on the table and how easy it was. I was shocked by the results.

Thanks a lot for watching please check out the links below, help me grow and support me if possible via spreading the word. You can also support me by donating to me on Patreon, watching the adverts, or using affiliate links when possible. Thanks for reading!

++Social Media Links


++Check out this little tabletop project, called Project1! (I’ll change it later most likely)

++Check out my website below!

++I Sometimes stream on Twitch!

++Check out some cool Merch

++Become a Patreon! Every dollar is appreciated!

++Purchase one of the printers I have!
Tivo Tarantula…

Anet A8

NEJE DK-8 Pro-5 500mW – Laser Cutter…

++A HUGE Special Thanks To Our Patreons for Helping to grow the channel!
Jamie Robinson

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.